Disabled Toilet Alarm Reset, Monitored, Stainless

  • Disabled Toilet Alarm DT7540.00M, Reset, Monitored, Stainless Steel imageDisabled Toilet Alarm DT7540.00M, Reset, Monitored, Stainless Steel image
  • Hover over image to enlarge

Part Number

  • DT7540.00M: Reset, Monitored, Stainless Steel

Features

  • Vandal resistant reset button and alarm controller
  • Pull cord fault monitoring
  • Illuminated reset button with activation delay
  • Internal buzzer
  • Input for pull cords
  • Button and buzzer activate on alarm
  • Status LED normally green, red on fault
  • Fault output for remote monitoring system
  • Stainless steel faceplate
  • Anti-tamper fixings available
  • Mounts in flush or surface single gang back box
  • Output for Folknoll remote monitoring systems

Description

Our vandal resistant disabled toilet alarm range offers tough, cost‑effective, BS 8300:2009 compliant systems suitable for public use. We supply stand‑alone toilet alarms, multiple toilet systems with remote monitoring and combined systems with disabled refuge EVC, fire telephone, building alarms, etc. Interfaces for BMS and transmission over IP are also available. Ideal for shops, offices, hotels, factories and similar locations.

OUR RESET UNITS

Our disabled toilet alarm reset units are local alarm controllers with integral reset buttons. The units continually monitor pull cords, call points, etc. activating beacon sounders and other indicators when an alarm is triggered. The reset button is used to cancel and reset the alarm after an incident has been resolved. Reset units are usually installed inside a toilet or alarm zone to ensure alarm responders visit the location in response to an alarm.

THE DT7540.00M RESET

The DT7540.00M Monitored Reset Button offers an illuminated reset button, an internal buzzer, pull cord fault monitoring and fault output. The faceplate is made from vandal resistant brushed finish stainless steel and annotated in black with the word RESET. Other finishes and alternative annotation are available on request. This unit can be mounted in a 35 mm flush or surface single gang back box (not supplied).

Products in this Range